Types and introduction of hydraulic seal static seals 1. Hydraulic seal O-ring seals are circular seals in cross-section, relying on pre-compression ￡ to eliminate gaps to achieve sealing, and can automatically increase the seal and sealing surface with the increase of pressure p contact stress, thereby improving the sealing effect. It can be used for static seal of high pressure end face and cylindrical surface, and also can be used for low pressure reciprocating dynamic seal with low movement speed. Inexpensive, simple, good sealing, automatic compensation after wear. 2. Various sealing gaskets for hydraulic sealing Combination sealing gasket, which is made of oil-resistant rubber seals
inner ring and steel outer ring, is easy to install and has reliable sealing. It is mostly used for end face sealing of threaded pipe joints, etc., and h-2 is the compression amount. 3. Hydraulic sealant The sealant coating has fluidity and can fill the gap between the two joint surfaces, and it can seal and prevent leakage under a certain tightening force. According to the properties of the film formed between the two bonding surfaces, it can be divided into four types: dry adhesion type, dry peelable type, non-dry sticky type and semi-dry viscoelastic type. It is divided into two categories: liquid sealant and anaerobic sealant. After dry peelable coating, the solvent evaporates quickly, forming an elastic film, which is easy to peel off from the adhesive. It has good vibration resistance, but it is easy to volatilize and difficult to use on a large area. The non-drying viscous sealant does not dry for a long time after application, and always maintains viscoelasticity. Therefore, it has good detachability, high vibration resistance and impact resistance, and is suitable for large-area coating. The semi-dry viscoelastic type is between the above two and has the advantages of both. Anaerobic sealant is suitable for pressure sealing of smaller planes such as threaded pipe joints, which can prevent impact loosening and leakage. The use method of liquid sealant and anaerobic sealant is: pretreatment (oil removal, rust removal, decontamination)→Coating (coating 0.06-0.1mm)→dry→Fasten. Company website: https://www.orksealing.com/
If you are looking for convenient, affordable , ORK brings plethora of options to suit your requirements and budget both. Check ORK Rubber Seal Products for more details.
You get a wide variety of security, durability and manageability options across rubber seals. Here’s a link of the brand ORK Rubber Seal Products.
Provide rubber seals strategists with enough funds to adequately market our company and the products and services it provides.