loading

Since 2006, Focus on rubber seals

the various kinds of washers and their uses -

by:ORK      2020-03-08
Is the gasket metal or non-metallic?A metal plate between the NUT and the bearing or in the joint.You can say the washing machine is a thin plate with holes.The plate evenly distributes the load of the nut or screw.
We can also use the gasket as a gasket or a pre-load indicator.They found the use for wear and locking devices.Another use of the washing machine is to reduce or suppress vibration.
The gasket is made of plastic, rubber, or metal.In Bolt connection, highQuality steel washers can be used to prevent loss of pre-load after we apply torque.Rubber and washers help to prevent water flow in pipe applications.
Another important use is to prevent corrosion, for example when we use steel screws that touch the surface of the aluminum.There are three main types of washers: flat washers, spring washers and lock washers.You can get different sizes of washers from the general washer manufacturer.
The normal washing machine helps to disperse the load in the connected connection.We use it to prevent damage to the surface of the joint.Also, we can use it to provide insulation when there is an electrical connection.
When the diameter of the hole is greater than the fixing nut, it is mainly used.The Fender washer is another type of washer with a larger outer diameter.The center hole is small and it can apply a load on a thin metal surface, such as a car fender.
If there is a hole that is worn out or rusted a lot, then we can use the Fender gasket to connect.Spherical washing machine comes with its ownAlign the nut and have one-Radian surface.To fix a few degrees, we use it with a fit nut.
This corrects the misplacement between parts.The washing machine for a penny is very large in diameter.It\'s small but has a big OD.In the UK they call all the big OD washers penny washers.
The Cup Spring washer is also called a cone washer or a Belleville washer.It has a slight taper deformation when we tighten it.This deformation creates a slight axial force in the joint.
Wave washers like this create wave forces in the axial direction.Spring pressure is generated when we tighten the spring.The force of the wave washer is not as large as the Belleville washer.
Sometimes they may find the use of a washing machine, but this is very rare.You can see many kinds from the manufacturer of spring washers.Split washing machine is a spring locker with split ring.
It has a spiral shape that helps to apply pressure to the joint.The gasket presses the gasket hard on the substrate.The Spring washer is left-So we can only tighten this on the right.
hand direction.
If we turn it to the left side, the raised edge will bite into the surface, which will prevent the fastener from becoming tight
Custom message
Chat Online 编辑模式下无法使用
Leave Your Message inputting...
Thank you for your enquiry. We will get back to you ASAP